#HELLO KITTY PDF IMAGES HOW TO#

Two new corners will be touching now, one from the top with the one on the bottom. However, you will be forming a 90-degree angle between the upper edge and the edge you just made by dragging the lower corner up and to the left. Pull it up and slightly to the left, almost as if you were folding that section in half lengthwise. Grab the bottom left corner of the folded section. Unfold and fold top and bottom towards the middle crease. Secure the wire with pins.įold the mask in half lengthwise. Then insert the nose wire into the fabric piece and set it all the way to the center on the top edge, where the curves are. Mask without filter pocket: Turn the fabric inside out through the opening you left earlier.You can insert a twist tie or craft wire into this channel. Mask with filter pocket: The stitching creates a nose wire channel into the filter pocket.Turn the whole thing inside out through one of the side openings and press. Leave both sides unstitched so that you can turn the whole thing inside out through it.Ĭlip the curves and snip the pointed edges at the top. Sew all around the edges with a quarter-inch seam allowance. Place the lining fabric on a flat surface with the right side up, then place the filter pocket on top of it, and finally place the main fabric on top with the wrong side up.Īlign the middle of all pieces and pin in place.

Pin and sew the sides.įind the middles of each fabric piece: Fold each of the three parts of your mask in half and fingerpress to mark the middle. Fold both sides of the pattern towards the middle as shown and cut out a rectangle of fabric according to its highest and widest parts.įold the side edges inward 1/4″ twice and press with an iron. If you don’t want a filter pocket – skip the stepĬut fabric for the filter pocket. This step is only for those of you who want to make a 3d face mask with a filter pocket. STEP 3: (OPTIONAL): Make the filter pocket

Tip: Before you cut your fabric, wash it thoroughly and iron it. You will need to cut two of these – one for the main piece and one for lining. Mark the fabric with sewist chalk or a washable pen, using the pattern as a guideline. Unfold the pattern you made earlier and set it on top of the fabric. We all have different facial sizes and features and the fits is a bit different, but as a rough sizing guide: Cut out the size you need.Īll seam allowances are 1/4 inches (6mm) unless noted otherwise. The pattern prints on just one piece of paper and includes 4 different sizes – S, M, L, and XL.

sewing machine (or you can hand sew this)ĭOWNLOAD: 3d face mask pattern (Free PDF file)ģD FACE MASK INSTRUCTIONS: STEP 1: Prepare the 3d face mask patternĭownload and print the 3d mask template without any scaling (print at actual size / 100%).

scissors (or rotary cutter and a cutting mat).

1/16″ round elastic (preferable) or 1/8″ flat elastic – 2 x 7-8″ long.

#HELLO KITTY PDF IMAGES HOW TO#

3.10 STEP 8: Make the three-dimensional formīefore we get to the instructions on how to sew a simple face mask, first you will need to prepare the required materials.įor this 3D mask with filter pocket, you will need the following supplies.3.5 STEP 3: (OPTIONAL): Make the filter pocket.3.4 STEP 2: Cut the fabric for the mask.3.3 STEP 1: Prepare the 3d face mask pattern.

Hello kitty pdf images